Barco CineVERSUM 110 R9010120 Owner's Manual page 35

No. Key name
1 Function keys
2 MENU
3 Address key
4 LOGO key
5 PAUSE
6 STBY
7 TEXT
8 AUTOIMAGE
9 Digit buttons
10 Lens control
11
VOL
12 Picture controls
13 DIGI ZOOM
14 FREEZE
15 PIP
16 ENTER
17 Cursor keys
18 BACK
19 EFFECTS
20 PIP ADJUST
21 RC operating indication
22 IR receiver
Led 1
Led 2
Led 3
R5976697 CINEVERSUM™ 110 06012004
Description
user programmable keys with functions for direct access.
Menu key, to enter or exit the Tool bar menu.
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
allows to recall the stored Logo (not in PiP mode)
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
to des-activate or activate the on screen dialog boxes and menus.
Auto image, to center the image on the active DMD surface.
direct input selection.
use these buttons to obtain the desired ZOOM, SHIFT, FOCUS.
Not used
use these buttons to obtain the desired picture analog level.
allows a digital Zoom of a part of the image
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
to confirm an adjustment or selection in the MENU.
On the local keypad and the RCU, the ENTER button additionally accesses the PIP
window re-size function
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
menu bar.
to leave the selected menu or item (go upwards to previous menu).
not yet implemented
allows to select a PiP window and change its configuration on screen
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
IR receiver
Blue
Standby : 0.2 sec on, 2 sec off
cooldown : 0.3 sec on, 0.3 sec off
Operating : continues on
error : 0.15 sec on, 0.15 sec off
not used
IR acknowledgement
4. Getting Started
31