Lucent Technologies PARTNER Advanced Communications System Installation Manual page 30

Paging System
If you connect a paging system from a
manufacturer other than Lucent Technologies, a
paging interface may be required.
1
Insert the modular plug into the PAGE jack on the
PARTNER ACS processor module (located near the
middle of the processor, just above the line jacks).
2
Route the cord as you did for line and extension cords,
then connect the other end of the cord to the paging
system.
Music-on-Hold Audio Source
The performance of music over telephone lines is a public performance under United States Copyright law.
Accordingly, in order for the performance of that music to be lawful, it must be licensed annually to the user by the
copyright owners or their representatives.
You can purchase a Magic On Hold system from Lucent Technologies, 1 800 446-5366, which includes the
required license for the first year. This license must be renewed annually.
1
Insert an RCA phono plug into the MUSIC ON HOLD
jack on the PARTNER ACS processor module (located
near the middle of the processor, below the line jacks).
2
Route the cord as you did for line and extension cords,
then connect the other end of the cord to the audio
source.
3
Place a call on hold and listen. If you do not hear
music at any setting, check Music On Hold (#602)"
and Music On Hold Volume (#614) in Chapter 5 of the
PARTNER Advanced Communications System
Programming and Use guide.
PAGE Jack
Paging System
(optional)
MUSIC ON HOLD
Jack
Audio Source
(optional)
Installation Procedures
27