Wall-Mounting A 5-Slot Carrier And Modules - Lucent Technologies PARTNER Advanced Communications System Installation Manual

Wall-Mounting a 5-Slot Carrier and Modules

Install the 5-Slot carrier within 5 feet (1.5 meters) of a properly grounded wall outlet (not controlled by a switch) and
the network interface jacks. In addition, when you mount the carrier on the wall, leave at least 1 foot (0.3 meter) of
clearance at the top and sides, and two feet (0.6 meter) at the front and bottom to ensure proper ventilation.
NOTE:
The location of each module within the carrier is important; place them as instructed in the following
procedure.
1
A) Hold the 5-slot carrier against the wall.
B) Using the four screw keyholes in the carrier as a
template, mark screw locations on the wall.
C) If you re mounting the carrier on plywood, start
four #12 screws supplied with the carrier leaving
the screw heads extending approximately 1/4
(.64 cm) from the wall. If you are mounting on
drywall, use wall anchors, which must be
purchased.
2
Before installing any modules, make sure the clear,
plastic protector has been removed from the
connector area on the rear of each module. To remove
the protector, grasp the tabs on the ends of the
protector and lift.
NOTE:
308EC and 206 modules must be to the left of any 200
and 400 modules.
3
A) Verify that the PARTNER ACS processor module
is in the center slot of the carrier. In the other
slots, from left to right, first install the 308EC or
206 modules followed by the 400 or 200
modules.
B) Align the module carefully in the appropriate slot,
and push slowly but firmly in the center of the
module until the connectors on the module lock
into place, and the module is attached to the rear
of the carrier.
!
CAUTION:
Do not force the module. If it does not insert easily,
remove the module, clear any obstruction, and
reinsert it.
14
Installation Procedures
Carrier
Tab
Tab
"
1
4