Installation Procedures; Wall-Mounting A Standalone Partner Acs Processor Module - Lucent Technologies PARTNER Advanced Communications System Installation Manual

Installation Procedures

Before installing the system, be sure you read the safety instructions on page ii.
The PARTNER Advanced Communications System can be installed in one of three configurations:
standalone PARTNER ACS processor module.
2-Slot carrier, which can hold up to two modules.
5-Slot carrier, which can hold up to five modules and includes a cover.
The standalone processor module or a carrier and its modules are referred to as the control unit. The control unit
must always be wall-mounted. See the following sections for wall-mounting instructions.
Wall-Mounting a Standalone
PARTNER ACS Processor Module
Install the PARTNER ACS processor module within 5 feet (1.5 meters)
of a properly grounded wall outlet (not controlled by a switch) and the
network interface jacks.
1
A) Hold the PARTNER ACS processor module
against the wall with the line and extension jacks
facing left.
B) Leave at least 1 foot (0.3 meters) clearance at
the top, front, and right side, and at least 2 feet
(0.6 meter) at the bottom and left side. This
allows you to access the jacks or expand the
system with another module, and ensures
adequate ventilation.
2
A) Insert one of the #8 sheet metal screws into the
screw hole at the top of the module.
B) If you are not installing a second module, insert
the other #8 sheet metal screw into the screw
hole at the bottom of the module. If you are
installing a second module, do not screw in the
bottom screw at this time.
C) Tighten the screw(s) until the mounting tracks
are snug against the wall. There must be a 3/8"
(1 cm) gap between the wall and the rest of the
module . Do not overtighten the screw(s) the
module will warp and fail to operate.
10
Installation Procedures
1' (0.3 m)
2' 1'
(0.6 m)
(0.3 m)
1' (0.3 m)