Lucent Technologies PARTNER Advanced Communications System Installation Manual page 36

7
A) Remove the screw at the top of the PARTNER
ACS processor module and remove the module
from the wall.
B) Mount the new PARTNER ACS processor
module by following the instructions in
''Wall-Mounting a Standalone PARTNER ACS
Processor Module''
the PARTNER ACS Processor Module''
this guide.
C) Remount the top module by following Steps 1
and 3 through 9 in
Carrier and Modules''
8
Connect the line and extension cords one at a time,
making sure to place the correct cords into their
corresponding jacks on the new module. (See
''Connecting Lines and Extensions''
guide.)
9
Reconnect the power cord.
Replacing Modules in a 5-Slot Carrier
!
WARNING:
Before starting, move the On/Off switch to "off", and unplug the power cord. Verify that you have
batteries installed in the PARTNER ACS processor module, and then disconnect the power cord
from the wall jack on the carrier.
1
A) Loosen the screw on the lower front of the carrier
s cover. Then place one hand on the handle on
the lower front and place your other hand on the
top of the cover.
B) Gently pull the cover up and away from the
carrier be careful not to break the tabs that
attach the cover to the carrier.
and ''Inserting Batteries in
earlier in
''Wall-Mounting a 2-Slot
earlier in this guide.
earlier in this
On/Off Switch
PFT
L
1
I
N
PFT
2 E
3 L
S I
N
PFT
E
4 L
S PAGE
I
N
E PFT
S 5 L
206 I
MODULE
N
E
6
S
206
MODULE
PFT
PROCESSOR
10 MODULE
PFT
E 206 206
11 16
X MODULE MODULE
T
12 E
E 17
N X
S T
13 18
E VOL
I
N
O
S
14 N 19
S I
MUSIC
O
15 20 ON
N HOLD
S
21
Handle
Screw
Equipment Upgrades
Power
Jack
33