TO MOVE A VOICE TERMINAL LOCATION
You can easily move your voice terminal to a new location.
1.
Disconnect the D8W Modular Cord from the voice terminal.
2.
Reroute or place new wiring from the control unit to the new location, following the
procedures described under "Installing Cord/Cabling" in the Installation section.
3.
Place the voice terminal in desired location.
4.
Connect the D8W Modular Cord to the voice terminal.
Note:
You do not have to change intercom numbers to move voice terminals.
5.
Test the voice terminal using the steps described in "Testing the VoiceTerminal."
TO SWAP VOICE TERMINAL LOCATIONS
Two people can trade locations and keep their voice terminals and intercom numbers by
completing the following steps:
1. Unplug both voice terminals at their "LINE" jacks on the bottom of each terminal.
Swap locations and plug into the line at the new location.
2. At the control unit, switch the plugs in the two voice terminal jacks.
3. Change the intercom numbers on the labels attached to the two terminal's cords. Each
person now has exactly the same service as before the "swap."
TO ADD A CARTRIDGE
You can increase the capabilities of your system by adding a cartridge. To add a cartridge:
1. Order the cartridge.
2. Install the new cartridge, following instructions packaged with it.
Warning:
Unplug the control unit power cord from the ac outlet before
inserting or removing a cartridge.
System Changes (cont'd)
37