To Add A Voice Terminal; To Add A Voice Terminal Accessory - AT&T MERLIN 410 Service Manual

TO ADD A VOICE TERMINAL

You can add voice terminals up to the system's limit: six for the Model 206, and ten for the
Model 410. Here are the steps:
Note:
This example describes modular cord installation. Similar steps can be used
with customer-installable cable. Cable must be used for distances greater than
400 feet and up to a maximum of 1000 feet.
1. Order the voice terminal (desk stand and modular cord, are included) and extension
cord (if needed). You may need to order an auxiliary power unit if the total number of
voice terminals and system-powered accessories (headset adapters or hands-free units)
exceeds eight (for the Model 206) or fourteen (for the Model 410).
2. Plug one end of the modular cord or the extension cord into the control unit and attach
the other end to the wall near the voice terminal.
3. Plug the modular cord into the wall-mounted extension cord.
4. Plug the other end of the modular cord into the "LINE" jack on the bottom of the new
voice terminal.
5. Label the cords with the intercom number of the voice terminal.
6. Label the buttons.
7. If you have Feature Package 1, program the features following the instructions pro-
vided in the User's Guide.

TO ADD A VOICE TERMINAL ACCESSORY

You can add a hands-free unit, or a headset adapter to any 10-button or 34-button voice ter-
minal.
1. Order the accessory. You may need to order an auxiliary power unit if the total
number of your terminals, hands-free units, and headset adapters exceeds eight (for the
Model 206) or fourteen (for the Model 410).
2. Plug the accessory into the "OTHER" jack on the bottom of the voice terminal.
Note:
Hands-free unit requires the Feature Package 1 cartridge.
36