Setting The Test Limits - Fluke 125 User Manual

Fluke 125
Users Manual

Setting the Test Limits

You can change the test limits used to generate the
messages OK , WARNING
The test limits apply to the selected bus type. To change
the test limits for another bus type do steps 1-5 on page 4-
2 first.
To change the test limits, do the following:
From the test screen open the
SETUP LIMITS menu. You will
see a screen like Figure 4-5. The
header shows the bus type.
Select the signal property for
which you want to set the limit.
Select the level to be adjusted:
LOW, HIGH or ! WARNING
Press
default setting.
4-8
, and NOT OK .
to set all limits to the
Change the limits.
A * in the SETUP LIMITS screen
indicates that a signal property
has limits that differ from the
default setting.
Press
not be involved in the test.
Accept the limits and return to the
test screen.
In the test screen the text LIMIT
will be followed by a * if any of the
limits is not the default limit.
Note
Changed limits will persist until:
- you change them again,
- you reset the test tool; resetting will restore the
default limits.
N/A if a limit should