Figure 3-2. Harmonics Screen
Show the input A voltage (VOLT),
input B current (AMP), or power
(WATT) harmonics.
Harmonics
Measuring Harmonics
Select %f to display harmonics
bars as a percentage of the
fundamental signal.
Select %r to display harmonics
bars as a percentage of the total
rms signal
Show the waveform
screen.
Show the bars screen.
For the waveform screen use the
F1 key to display the voltage
(input A), the current (input B), or
both waveforms.
If the waveform screen is shown,
the arrow keys key are locked.
Set cursor measurements ON or
OFF, see Using Cursors below.
3
3-3