Looking At The Measurement Connections; Input A; Input B; Com - Fluke 125 User Manual

Looking at the Measurement
Connections
Look at the top of the test tool. The test tool provides two
4-mm safety shielded banana jack inputs (red input A and
gray input B) and a black safety 4-mm banana jack input
(COM). (See Figure 1-3.)

Input A

You can always use the red input A for all single input
measurements possible with the test tool.

Input B

For measurements on two different signals you can use
the gray input B together with the red input A .

COM

You can use the black COMmon as single ground for low
frequency measurements, and for Continuity, Ohm (Ω),
Diode, and Capacitance measurements.
General Operating Instructions

Looking at the Measurement Connections

Warning
To avoid electrical shock or fire, use only one
COM (common) connection, or ensure that
all connections to COM
potential.
Figure 1-3. Measurement Connections
1
are at the same
1-5