Fluke 125
Users Manual
Start the TrendPlot. You will see a
screen like figure 5-1.
You can restart a TrendPlot by
pressing the F2 RESTART key.
Stop the TrendPlot.
Figure 5-1. TrendPlot Reading
5-2
The test tool continuously logs all readings to memory and
displays these as graphs. If input A and input B are on, the
upper graph belongs to input A.
Automatic vertical scaling and horizontal time compression
resizes the TrendPlot to fit on the screen. The TrendPlot is
built up on the screen from left to right until the screen is
full. The automatic time scaling then compresses this
information to about half the screen.
When a new minimum or maximum value is
detected a beep occurs.
Note