Performing Fieldbus Measurements - Fluke 125 User Manual

Fluke 125
Users Manual

Performing Fieldbus Measurements

To perform fieldbus measurements do the following:
Open the application mode menu.
Highlight BUSHEALTH.
Open the bus selection menu:
4-2
Select the bus type.
Select User 1 or User 2 if you
want to create a customized set
of limits to test other (non
standard) bus systems. See
page 4-8 for setting the limits.
Default settings are ControlNet for
User1 and Foundation Fieldbus
H1 for User2.
Accept your choice.
For bus types followed by 3 dots
... a new menu will open:
Use
required item and press
You will see a screen like fig 4.2.
Select the appropriate input A and
input B test leads or probe type.
Connect the inputs as indicated in figure 4-1.
Use the test tool inputs as shown in table 4-1.
to select the
.