Recorder Functions; Fieldbus Measurements (Bushealth) - Fluke ScopeMeter 225C Getting Started Manual

Fluke 19xC-2x5C
Getting Started

Recorder Functions

First, choose a measurement in Scope or Meter mode.
Show the recorder functions. Select a
RECORDER
recorder function (Scope Trendplot, Scope
ANALYZE
Record, or Meter Trendplot), then press
to display the recorder key labels:
Start ( ) or stop (
RUN
Show the recorder options.
time reference is time of day
Reference:
(
Time of Day
).
Start
In Scope Record:
Display Glitches:
10 kHz filter on.
Mode: Single Sweep
until memory is full, then stops.
Mode: Continuous
continuously; deletes first samples if
memory is full.
Mode: on Ext. ...
or continue (
the meter input (
trigger per division in
8
) recording.
STOP
) or time from start (
From
glitch detection on, or
: stores samples
: stores samples
: start ( ), stop (
Start Stop
) recording if triggered via
Run
). requires one
Ext. Run
mode.
VIEW ALL
In Trend Plot:
Reading 1 (2)... (
Meter) show the measurement function
(
menu.
VIEW ALL
NORMAL
EXIT

Fieldbus Measurements (Bushealth)

The Bushealth function is standard available in the
Fluke 215C-225C.
Selecting the Bus Type
Show the function selection screen. Select
ANALYZE
Bushealth , then press
Highlight the required bus type, the press
that a submenu will follow on this selection.
The test tool shows the bushealth screen.
Show information on how to connect the test
)
tool to the bus (
Show the bus signal eye pattern (waveform).
Scope) or
Measurement...
: see all stored samples.
: see the most recent 9 divisions.
: exit the recorder mode.
.
. Dots ... behind a bus type indicate
).
WIRING INFO