Conversion To Another Type Of Gas; Setting Elements - Baumatic BT2355SS User Manual

Conversion to another type of gas

For the conversion procedure the
appliance need not be pulled out from its
location.
Before starting to work on conversion,
disconnect the appliance from the mains.
Replace the existing nozzles of declared
nominal heat input with adequate nozzles
for the new type of gas (see table).
Adjust the nozzle for the minimum heat
input rate as long as it requires to arrive
at the minimum heat input.
Never unscrew nozzles for minimum heat
input rate for more than 1,5 turn.
After the conversion is done, stick the
new sticker with the actual gas
specifications of the appliance over the
old one.
Check that electrical cables, thermostat
probe and thermal elements are located
away from the gas jet!

Setting elements

Elements for regulation of cooking
burners are accessible when the control
panel is removed.
Remove the cooktop grid and burner
crowns with caps.
Remove the control buttons.
Unscrew bottom tightening screws from
the control panel and remove the panel.
Cooking zone burner (fig. 1 )
1 Burner crown
cap
2 Burner crown
with burner
cap support
3 Thermal probe
4 Ignition plug
1
5 Nozzle
Instructions for use, installation and connection
Triple-ring burner (fig. 2)
Safety gas faucet (fig. 3)
Non-safety gas faucet (fig. 3a)
Elements to be replaced or reset
when altering the type of gas
Cooking zone
burner
Nominal heat
input
Minimum
heat input
5 nozzles
13 Setting screw
for minimum
heat input rate
13 Setting screw
for minimum
heat input rate
Fig. Element
number code
1, 2 5
3, 3a 13
33