Hard Disk Drive Jumper Settings; Installing A Security U-Bolt - IBM A40I TYPE 2271 Hardware Maintenance Manual

Hard disk drive jumper settings

IDE hard disk drives for the NetVista series computers use jumpers to set the
drives as primary (master) or secondary (slave).

Installing a security U-bolt

To install a U-bolt, do the following:
1. Remove the cover.
Note: For drives not shown below, refer to the label on the hard disk drive for the hard
disk drive settings.
1 Primary (Master) Hard Disk Drive
2 Secondary (Slave) Hard Disk Drive
Chapter 4. Installing Options
21