Cisco CP-7970G Administration Manual page 134

Telephony Features Available for the Phone
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature
Do Not Disturb (DND)
Enbloc Dialing
(SCCP phones only)
Fast Dial Service
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.5
5-10
Description
When DND is turned on, either no audible rings
occur during the ringing-in state of a call, or no
audible or visual notifications of any type occur.
You can configure the phone to have a softkey
template with a DND softkey or a phone-button
template with DND as one of the selected features.
The following DND-related parameters are
configurable in Cisco Unified Communications
Manager Administration:
Do Not Disturb—Choose Device > Phone >
•
Phone Configuration.
DND Option—Choose "Call Reject" (to turn
•
off all audible and visual notifications), or
"Ringer Off" (to turn off only the ringer). DND
Option appears on both the Common Phone
Profile window and the Phone Configuration
window (Phone Configuration window value
takes precedence).
DND Incoming Call Alert—Choose the type of
•
alert to play, if any, on a phone for incoming
calls when DND is active. This parameter is
located on both the Common Phone Profile
window and the Phone Configuration window
(Phone Configuration window value takes
precedence).
BLF Status Depicts DND—Enables DND
•
status to override busy/idle state.
Enbloc dialing enables SCCP to send all digits of a
phone number simultaneously. This feature must
be disabled if either Forced Authorization Codes
(FAC) or Client Matter Codes (CMC) dialing is
being used.
Allows a user to enter a Fast Dial code to place a
call. Fast Dial codes can be assigned to phone
numbers or Personal Address Book entries. (See
"Services" in this table.)
Chapter 5 Configuring Features, Templates, Services, and Users
Configuration Reference
Cisco Unified Communications Manager
Features and Services Guide,
To disable enbloc dialing, in Cisco Unified
Communications Manager Administration,
go to Device > Phone. On the Phone
Configuration window, in the Product
Specific Configuration Layout area, uncheck
the Enbloc Dialing check box, then click
Apply Config, then click Save.
For more information, refer to:
Cisco Unified Communications Manager
•
Administration Guide,
Phone Configuration.
Cisco Unified Communications Manager
•
System Guide,
Services.
Do Not Disturb.
Cisco Unified IP
Cisco Unified IP Phone
OL-23092-01