Factory Reset - D-Link DES-3624i User Manual

The computer will be rebooted once you press RESTART.

Factory Reset

Before performing a Factory Reset, be absolutely certain that this is what you want to do. Once the reset is done, all of
the Switch's settings stored in NV-RAM (including TCP/IP parameters, SNMP parameters, the enabled/disabled settings
of ports, security settings, etc.) will be erased and restored to values present when the Switch was purchased.
Note: After performing the Factory Reset, make sure to redefine the IP settings for the Switch in the Configure IP
Address menu. Then perform a Restart System on the Switch. After these three procedures are performed,
your Factory Reset is complete.
Choose Factory Reset from the main menu. The following screen appears:
100
Figure 6-63. Restart System screen
Stackable NWay Ethernet Switch User's Guide
Using the Console Interface