Port Packet Error Statistics - D-Link DES-3624i User Manual

Stackable NWay Ethernet Switch User's Guide
Frames Recv. The number of good frames received. This also includes local and dropped packets.
Frames Sent The number of good frames sent from the respective port.
Total Bytes Recv. The number of bytes received, good and bad.
Total Frames Recv. The number of frames received, good and bad.
Last Seen MAC The MAC address of the last device that sent packets over this port.

Port Packet Error Statistics

To access the third item on the Traffic Statistics menu, choose Port Packet Error Statistics. The following table
appears:
Select the desired device in the Switch field, the desired setting in the Ports field, and the desired increment setting in the
Update Interval field: 5 sec, 15 sec, 30 sec, 1 min, or Suspend. Press CLEAR COUNTERS to clear all counters for a
desired port group.
The statistic counters displayed are defined as follows:
Speed If the link is up, the speed and duplex status will be displayed; if the link is down "–" will be displayed.
CRC Error The number of frames that fail the CRC integrity check.
Oversize Frames The number of good frames with length greater than 1536 bytes and therefore are greater than
the maximum legal length.
Bad Fragment The number of packets less than 64 bytes with either bad framing or an invalid CRC. These are
normally the result of collisions.
Using the Console Interface
Figure 6-56. Port Packet Error Statistics table
93