Stack Operation - D-Link DES-3624i User Manual

Stackable NWay Ethernet Switch User's Guide
The system fans are used to dissipate heat. The sides of the system also provide heat vents to serve the same
purpose. Do not block these openings, and leave adequate space at the rear and sides of the Switch for proper
ventilation. Be reminded that without proper heat dissipation and air circulation, system components might
overheat, which could lead to system failure.

Stack Operation

The DES-3624i, DES-3624iF, and DES-3624iFM are all intelligent Switches capable of acting as a master for up to
three slave Switches (DES-3624, DES-3624F, or DES-3624FM). Each port is referred to by unit ID and port number in
your DES-3624 Series stack.
To set up a stack, a one-port Stacking input/output module is needed for each client Switch and a three-port Stacking
input/output module is needed for the master Switch. Once the modules have been installed, use a cascade cable to
connect each client Switch to the master Switch.
Please note that two client switches can also be connected via the Stacking input/output ports.
The following diagram displays some possible switch stack connections:
Identifying External Components
Figure 3-4. Switch stack with one master and three slaves
19