D-Link DES-3624i User Manual page 108

speed/duplex field above and flow control is enabled, flow control (whether f u ll- or half-duplex) will only be
implemented if the other device can auto-negotiate flow control. Note that you must reboot the Switch before a
flow control change can take effect.
4. Configure the Priority setting for packets passing through this port, using IEEE 802.1p/q tagging. Select Low,
High or Normal. If the network is congested, the Switch handles packets with a higher priority before those with
lower priority.
5. Configure the Locked setting to prevent the port from learning the MAC addresses of new hosts. This will help
keep intruders off your network since any packet coming from an unknown source address will be dropped by the
Switch, that is, not added to your MAC Address Forwarding Table. Select Enabled or Disabled.
6. Configure the Rising Action setting under Broadcast Storm from three choices: Do Nothing, Blocking, or
Blocking-Trap and enter a Rising Threshold between 1 and 1488000 (the default is 500).
7. Configure the Falling Action setting under Broadcast Storm from three choices: Do Nothing, Forwarding, or
Forwarding-Trap and enter a Falling Threshold between 1 and 1488000 (the default is 250).
8. The Port Type, STP State, and Status are read-only fields indicating the current condition of the port you have
selected.
9. Click Apply to let your changes take effect.
108
Stackable NWay Ethernet Switch User's Guide
Web-Based Network Management