Rear Panel; Side Panels - D-Link DES-3624i User Manual

Rear Panel

The rear panel of the DES-3624, DES-3624F, and DES-3624FM consist of a slot (labeled Slot2) for a Stacking input/output
port and an AC power connector. The rear panel of the DES-3624i, DES-3624iF, and DES-3624iFM consist of two slots
(labeled Slot2 and Slot3). Slot2 is for Stacking input/output ports Sio1, Sio2, and Sio3. Slot3 is for an optional Gigabit
Ethernet uplink (MDI-II) port. The following shows the rear panel of the Switches.
The optional Gigabit Ethernet slide-in module is an uplink/MDI-II (media dependent interface) port for uplink to
another Switch (DES-3624i, DES-3624iF, and DES-3624iFM only). Two models are available, one-port and two-
port.
The Stacking input/output port slide-in module in the rear panel is for stacking to another device to implement a
high-port count, manageable Switch. The three-port module is for a master device and a one-port module is for a
client device.
The AC power connector is a three-pronged connector that supports the power cord. Plug in the female connector of
the provided power cord into this connector, and the male into a power outlet. Supported input voltages range from
100 ~ 240 VAC at 50 ~ 60 Hz.

Side Panels

The right side panel of the Switch contains two system fans (see the bottom part of the diagram below). The left side panel
contains heat vents.
18
Figure 3-2. Rear panel view of the Switches
Figure 3-3. Side panel views of the Switch
Stackable NWay Ethernet Switch User's Guide
Identifying External Components