Configuring Spanning Tree - D-Link 3100 24P - DGS Switch - Stackable User Manual

Gigabit stackable managed switch
Table of Contents

Advertisement

DGS-3100 Series Gigabit Stackable Managed Switch User Manual

Configuring Spanning Tree

Spanning Tree Protocol (STP) provides tree topography for any arrangement of bridges, as well as providing a single path
between end stations on a network, thus eliminating loops.
Loops occur when alternate routes exist between hosts. Loops in an extended network can cause bridges to forward traffic
indefinitely, resulting in increased traffic and reducing network efficiency.
The device supports the following STP versions:
Version
Classic STP
Rapid STP
Multiple STP
The STP Bridge Global Settings Page contains parameters for enabling STP on the device. This section contains the
following topics:
Defining Spanning Tree Global Parameters
Defining STP Port Settings
Defining Multiple Spanning Tree Configuration Identification
Defining MSTP Port Information
85
Description
Provides a single path between end stations, preventing loops from occurring.
Detects and uses network topologies that provide faster convergence of the spanning tree,
without creating forwarding loops.
Provides various load balancing scenarios. For example, if port A is blocked in one STP
instance, the same port can be placed in Forwarding State in another STP instance.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-3100 series

Table of Contents