Table of Contents
Advertisement
DGS-3100 Series Gigabit Stackable Managed Switch User Manual
Defining Ports
Configuring Port Properties
Viewing Port Properties
Configuring Port Properties
The Port Setting Page contains parameters for configuring port or LAG properties. Gigabit ports operate in full duplex
mode only, and take on certain characteristics that are different from the other choices listed. The copper ports also support
auto MDI/MDIX for cross over cables.
To define port parameters:
1. Click Configuration >Port Configuration > Port Setting. The Port Setting Page opens:
The Port Setting Page contains the following fields:
Field
Unit
From Port
From LAG
To Port
To LAG
State
31
Figure 2-5 Port Setting Page
Description
Defines the stacking member or LAG for which the port settings are displayed.
Defines the port number from which the port configuration will apply.. This field appears only if
a unit number is selected in the Unit field.
Defines the LAG number from which the port configuration will apply. This field appears only
if LAG is selected in the Unit field.
Defines the port number to which ports the configuration will apply. This field appears only if a
unit number is selected in the Unit field.
Defines the LAG number to which the port configuration will apply. This field appears only if
LAG is selected in the Unit field.
Defines whether the interface interface is currently operational or non-operational. The possible
field values are:
Advertisement
Table of Contents
