Applying A Vlan Access Map - Cisco 7609 Configuration Manual

Configuring VLAN ACLs
Configuring an Action Clause in a VLAN Access Map Sequence
To configure an action clause in a VLAN access map sequence, perform this task:
Command
Router(config-access-map)# action {drop [log]} |
{forward [capture]} | {redirect {{ethernet |
fastethernet | gigabitethernet | tengigabitethernet}
slot/port} | {port-channel channel_id}}
Router(config-access-map)# no action {drop [log]} |
{forward [capture]} | {redirect {{ethernet |
fastethernet | gigabitethernet | tengigabitethernet}
slot/port} | {port-channel channel_id}}
When configuring an action clause in a VLAN access map sequence, note the following syntax
information:
•
•
•
•
•
•
•
•
•
•
See the

Applying a VLAN Access Map

To apply a VLAN access map, perform this task:
Command
Router(config)# vlan filter map_name {vlan-list
vlan_list | interface type
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
23-14
You can set the action to drop, forward, forward capture, or redirect packets.
VACLs applied to WAN interfaces support only the forward capture action. VACLs applied to WAN
interfaces do not support the drop, forward, or redirect actions.
Forwarded packets are still subject to any configured Cisco IOS security ACLs.
The capture action sets the capture bit for the forwarded packets so that ports with the capture
function enabled can receive the packets. Only forwarded packets can be captured. For more
information about the capture action, see the
The log action is supported only on Supervisor Engine 2.
VACLs applied to WAN interfaces do not support the log action.
When the log action is specified, dropped packets are logged in software. Only dropped IP packets
can be logged.
The redirect action allows you to specify up to five interfaces, which can be physical interfaces or
EtherChannels. You cannot specify packets to be redirected to an EtherChannel member or a VLAN
interface.
For systems with a Supervisor Engine 2, the redirect interface must be in the VLAN for which the
VACL access map is configured. For systems with Supervisor Engine 1, the redirect interface must
be in the redirected packet's source VLAN.
Use the no keyword to remove an action clause or specified redirect interfaces.
"VLAN Access Map Configuration and Verification Examples" section on page
1 2
number } CP_CmdPlain
Purpose
Configures the action clause in a VLAN access map
sequence.
Deletes the action clause in from the VLAN access map
sequence.
"Configuring a Capture Port" section on page
Purpose
Applies the VLAN access map to the specified VLANs or
WAN interfaces.
Chapter 23 Configuring Network Security
23-15.
78-14064-04
23-16.