Cisco 7609 Configuration Manual page 487

Cisco ios software configuration guide—12.1e
Hide thumbs Also See for 7609:
Table of Contents

Advertisement

Chapter 33
Configuring NDE
A typical cache entry that is removed is the entry for flows to and from a Domain Name Server (DNS)
or TFTP server. This entry might not be used again after it is created. The PFC saves space in the MLS
cache for other data when it detects and ages out these entries.
If you need to enable MLS fast aging time, initially set the value to 128 seconds. If the size of the MLS
cache continues to grow over 32K entries, decrease the setting until the cache size stays below 32K. If
the cache continues to grow over 32K entries, decrease the normal MLS aging time.
To configure the MLS aging time, perform this task:
Command
Router(config)# mls aging {fast [threshold {1-128} |
time {1-128}] | long 64-900 | normal 32-4092}
Router(config)# no mls aging {fast | long | normal}
This example displays how to configure the MLS aging time:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# mls aging fast threshold 64 time 30
To display the MLS aging-time configuration, perform this task:
Command
Router# show mls aging
This example shows how to display the MLS aging-time configuration:
Router# show mls aging
normal aging false
fast aging
long aging
Router#
Configuring Sampled NetFlow
These sections describe how to configure sampled NetFlow on the PFC:
Note
78-14064-04
enable timeout
------ -------
300
false
32
false
900
Configuring Sampled NetFlow Globally, page 33-12
Configuring Sampled NetFlow on a Layer 3 Interface, page 33-12
Release 12.1(13)E and later releases support sampled NetFlow on the PFC.
NDE on the MSFC does not support sampled NetFlow.
With the full-interface or destination-source-interface flow masks, you can enable or disable
sampled NetFlow on individual Layer 3 interfaces. With all other flow masks, sampled NetFlow is
enabled or disabled globally.
Purpose
Configures the MLS aging time for an MLS cache entry.
Reverts to the default MLS aging time.
End with CNTL/Z.
Purpose
Displays the MLS aging-time configuration.
packet threshold
----------------
N/A
100
N/A
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Configuring NDE
33-11

Advertisement

Table of Contents
loading

This manual is also suitable for:

7600 series

Table of Contents