Configuring A Range Of Interfaces - Cisco 7609 Configuration Manual

Configuring a Range of Interfaces

Configuring a Range of Interfaces
The interface-range configuration mode allows you to configure multiple interfaces with the same
configuration parameters. After you enter the interface-range configuration mode, all command
parameters you enter are attributed to all interfaces within that range until you exit out of the
interface-range configuration mode.
To configure a range of interfaces with the same configuration, perform this task:
Command
Router(config)# interface range
{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]}
| {type slot/port - port [, type slot/port - port]} |
{macro_name [, macro_name]}}
Router(config)# no interface range
{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]}
| {macro_name [, macro_name]}}
When configuring a range of interfaces, note the following syntax information:
•
•
•
•
•
•
•
•
•
•
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
6-4
The space before the dash is required.
You can enter up to five comma-separated ranges.
You are not required to enter spaces before or after the comma.
You must add a space between the interface numbers and the dash when using the interface range
command. For example, interface range fastethernet 1 - 5 is valid syntax; interface range
fastethernet 1-5 is invalid.
With releases earlier than Release 12.1(14)E, the interface range command supports these interface
keywords:
– ethernet
fastethernet
–
– gigabitethernet
tengigabitethernet
–
With Release 12.1(14)E and later releases, the interface range command supports these additional
interface keywords:
pos
–
– loopback
tunnel
–
With Release 12.1(14)E and later releases, you can use the no interface range command to delete
VLAN interfaces.
With releases earlier than Release 12.1(14)E, you cannot use the no keyword with the range
keyword to delete VLAN interfaces.
With Release 12.1(14)E and later releases, you can use the interface range command to create
VLAN interfaces.
With releases earlier than Release 12.1(14)E, you cannot use the interface range command to create
VLAN interfaces: the interface range command is supported only with VLAN interfaces that have
been configured with the interface vlan command. You can enter the show running-configuration
command to display the configured VLAN interfaces.
Purpose
Selects the range of interfaces to be configured.
Selects the range of VLAN interfaces to remove.
Chapter 6 Configuring Interfaces
78-14064-04