Cisco 7609 Configuration Manual page 473

Chapter 32 Configuring PFC QoS
This example shows how to set the PFC QoS statistics data export interval and verify the configuration:
Router(config)# mls qos statistics-export interval 250
Router(config)# end
Router# show mls qos statistics-export info
QoS Statistics Data Export Status and Configuration information
---------------------------------------------------------------
Export Status : enabled
Export Interval : 250 seconds
Export Delimiter : |
Export Destination : Not configured
QoS Statistics Data Export is enabled on following ports:
---------------------------------------------------------
FastEthernet5/24
QoS Statistics Data export is enabled on following shared aggregate policers:
-----------------------------------------------------------------------------
aggr1M
QoS Statistics Data Export is enabled on following class-maps:
---------------------------------------------------------------
class3
Router#
Configuring PFC QoS Statistics Data Export Destination Host and UDP Port
To configure the PFC QoS statistics data export destination host and UDP port number, perform this task:
Command
Step 1
Router(config)# mls qos statistics-export
destination {host_name | host_ip_address}
{port port_number | syslog
[facility facility_name]
[severity severity_value]}
Router(config)# no mls qos statistics-export
destination
Step 2
Router(config)# end
Step 3
Router# show mls qos statistics-export info
When the PFC QoS data export destination is a syslog server, the exported data is prefaced with a syslog
Note
header.
Table 32-3
Table 32-3 Supported PFC QoS Data Export Facility Parameter Values
Name
kern
user
mail
daemon
78-14064-04
lists the supported PFC QoS data export facility and severity parameter values.
Definition
kernel messages
random user-level messages
mail system
system daemons
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Purpose
Configures the PFC QoS statistics data export destination
host and UDP port number.
Clears configured values.
Exits configuration mode.
Verifies the configuration.
Name Definition
cron cron/at subsystem
local0 reserved for local use
local1 reserved for local use
local2 reserved for local use
Configuring PFC QoS
32-75