Cisco 7609 Configuration Manual page 56

Protecting Access to Privileged EXEC Commands
For example, if you want many users to have access to the clear line command, you can assign it level 2
security and distribute the level 2 password widely. If you want more restricted access to the configure
command, you can assign it level 3 security and distribute that password to more restricted users.
These tasks describe how to configure additional levels of security:
•
•
•
•
•
Setting the Privilege Level for a Command
To set the privilege level for a command, perform this task:
Command
Step 1
Router(config)# privilege mode level level
command
Step 2
Router(config)# enable password level level
[encryption-type] password
To display the password or access level configuration, see the
and Privilege Level Configuration" section on page
Changing the Default Privilege Level for Lines
To change the default privilege level for a given line or a group of lines, perform this task:
Command
Router(config-line)# privilege level level
To display the password or access level configuration, see the
and Privilege Level Configuration" section on page
Logging In to a Privilege Level
To log in at a specified privilege level, perform this task:
Command
Router# enable level
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
3-18
Setting the Privilege Level for a Command, page 3-18
Changing the Default Privilege Level for Lines, page 3-18
Logging In to a Privilege Level, page 3-18
Exiting a Privilege Level, page 3-19
Displaying the Password, Access Level, and Privilege Level Configuration, page 3-19
Chapter 3 Configuring the Cisco 7600 Series Router for the First Time
Purpose
Sets the privilege level for a command.
Specifies the enable password for a privilege level.
"Displaying the Password, Access Level,
3-19.
Purpose
Changes the default privilege level for the line.
"Displaying the Password, Access Level,
3-19.
Purpose
Logs into a specified privilege level.
78-14064-04