Troubleshooting Ip Mls - Cisco 7609 Configuration Manual

Troubleshooting IP MLS

Vlan 1 Statistics Information:
-------------------------------
65280 Layer 2 Packets Bridged, 0 Bytes
65280 Layer 3 Packets Input, 0 Bytes
65280 Layer 3 Packets Output, 0 Bytes
Slot 3
=======
(Information Deleted)
Router#
Troubleshooting IP MLS
Table 19-2
problems.
Table 19-2 IP MLS Debugging Commands
Command
[no] debugging l3-mgr events
[no] debugging l3-mgr packets
[no] debugging l3-mgr global
[no] debugging l3-mgr all
To configure the IP MLS-related debugging commands, perform this task:
Command
Router# debugging mls {ip {all | error | events |
messages | multicast} | rp {all | error| events | ip
| locator | packets | verbose}}
Router# {no debugging | undebug} {all | {mls {ip {all
| error | events | messages | multicast} | rp {all |
error| events | ip | locator | packets | verbose}}}
This example shows how to configure all IP debugging:
Router# debugging mls ip all
mls ip all debugging is on
Router#
Enter the show tech-support command to display system information.
Note
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
19-14
describes IP MLS-related debugging commands that you can use to troubleshoot IP MLS
Chapter 19 Configuring IP Unicast Layer 3 Switching on Supervisor Engine 1
Description
Displays Layer 3 manager-related events.
Displays Layer 3 manager packets.
Displays bug trace of IP global purge events.
Turns on all Layer 3 manager debugging messages.
Purpose
Configures IP-MLS debugging.
Disables IP-MLS debugging.
78-14064-04