Configuring Nde Flow Filters - Cisco 7609 Configuration Manual

Chapter 33 Configuring NDE
Version 1 flow records
0 flows exported in 0 udp datagrams
0 flows failed due to lack of export packet
0 export packets were sent up to process level
0 export packets were dropped due to no fib
0 export packets were dropped due to adjacency issues
Router#

Configuring NDE Flow Filters

These sections describe NDE flow filters:
•
•
•
•
•
•
NDE Flow Filter Overview
By default, all expired flows are exported until you configure a filter. After you configure a filter, only
expired and purged flows matching the specified filter criteria are exported. Filter values are stored in
NVRAM and are not cleared when NDE is disabled.
To display the configuration of the NDE flow filters you configure, use the show mls nde command
described in the
Configuring a Port Flow Filter
To configure a destination or source port flow filter, perform this task:
Command
Router(config)# mls nde flow {exclude | include}
{dest-port number | src-port number}
Router(config)# no mls nde flow {exclude | include}
This example shows how to configure a port flow filter so that only expired flows to destination port 23
are exported (assuming the flow mask is set to ip-flow):
Router(config)# mls nde flow include dest-port 35
Router(config)#
78-14064-04
NDE Flow Filter Overview, page 33-15
Configuring a Port Flow Filter, page 33-15
Configuring a Host and Port Filter, page 33-16
Configuring a Host Flow Filter, page 33-16
Configuring a Protocol Flow Filter, page 33-16
Clearing an NDE Flow Filter, page 33-17
"Displaying the NDE Configuration" section on page
Purpose
Configures a port flow filter for an NDE flow.
Clears the port flow filter configuration.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Configuring NDE
33-17.
33-15