Accessing The Cli Through Telnet - Cisco 7609 Configuration Manual

Accessing the CLI
To make a console connection, perform this task:
Command
Step 1
Press Return.
Step 2
Router> enable
Step 3
Password: password
Router#
Step 4
Router# quit
After making a console connection, you see this display:
Press Return for Console prompt
Router> enable
Password:
Router#

Accessing the CLI through Telnet

Note Before you can make a Telnet connection to the router, you must configure an IP address (see the
"Configuring IP Routing and Addresses" section on page
The router supports up to eight simultaneous Telnet sessions. Telnet sessions disconnect automatically
after remaining idle for the period specified with the exec-timeout command.
To make a Telnet connection to the router, perform this task:
Command
Step 1
telnet {hostname | ip_addr}
Step 2
Password: password
Router#
Step 3
Router> enable
Step 4
Password: password
Router#
Step 5
Router# quit
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
2-2
Purpose
Brings up the prompt.
Initiates enable mode enable.
Completes enable mode enable.
Exits the session when finished.
12-2).
Purpose
Makes a Telnet connection from the remote host, to the
router you want to access.
Initiates authentication.
If no password has been configured, press
Note
Return.
Initiates enable mode enable.
Completes enable mode enable.
Exits the session when finished.
Chapter 2 Command-Line Interfaces
78-14064-04