Configuring Appletalk Routing, Cable Ranges, And Zones - Cisco 7609 Configuration Manual

Configuring AppleTalk Routing, Cable Ranges, and Zones

Configuring AppleTalk Routing, Cable Ranges, and Zones
For complete information and procedures, refer to these publications:
•
•
To configure routing for AppleTalk, perform this task beginning in global configuration mode:
Command
Step 1
Router(config)# appletalk routing
Step 2
Router(config)# interface {vlan vlan_ID} |
1
{type slot/port} | {port-channel
port_channel_number}
Step 3
Router(config-if)# appletalk cable-range
cable_range
Step 4
Router(config-if)# appletalk zone zone_name
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# end
Step 7
Router# show interfaces [{vlan vlan_ID} |
1
{type slot/port} | {port-channel
port_channel_number}]
Router# show appletalk interfaces [{vlan vlan_ID}
1
| {type slot/port} | {port-channel
port_channel_number}]
Router# show running-config interfaces [{vlan
vlan_ID} | {type
port_channel_number}]
1. type = ethernet, fastethernet, gigabitethernet, tengigabitethernet, or ge-wan
This example shows how to enable AppleTalk routing and assign an AppleTalk cable-range and zone
name to interface VLAN 100:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# appletalk routing
Router(config)# interface vlan 100
Router(config-if)# appletalk cable-range 100-100
Router(config-if)# appletalk zone Engineering
Router(config-if)# no shutdown
Router(config-if)# end
Router# copy running-config startup-config
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
12-6
Cisco IOS AppleTalk and Novell IPX Configuration Guide, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/atipx_c/index.htm
Cisco IOS AppleTalk and Novell IPX Command Reference, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/atipx_r/index.htm
1
slot/port} | {port-channel
Chapter 12
Purpose
Enables AppleTalk routing.
Selects an interface to configure.
Assigns a cable range to the interface.
Assigns a zone name to the interface.
Enables the interface.
Exits configuration mode.
Verifies the configuration.
End with CNTL/Z.
Configuring Layer 3 Interfaces
78-14064-04