Connecting The Connectors - Brother RH-981A Instruction Manual

3-17-5. Connecting the connectors

3023Q
1. Insert the 3-pin connectors [8], [9] and [10] of the
valve harness into the solenoid valves of the valve
unit (1) so that the label numbers match.
2. Insert the 15-pin connector (2) into the connector of
the indexer cord (3).
3. Open the rear cover (4) of the control box.
4. Insert the connector (5) of the indexer cord (3) in the
position shown in the illustration.
5. Secure the cord with the cord clamp.
6. Insert the two pins of limit switch (R) (6) and the two
pins of limit switch (L) (7) into the 15-pin connector
terminals with matching numbers.
7. Connect the three pins of the cylinder sensor (8) into
the 15-pin connector so that the cable colors match
the connector numbers as given in the table below.
* If the cable colors are red, white and black, refer
to the colors in brackets.
Note: First
inserting the pins, and then after inserting the
pins, re-connect the connector.
3024Q
Limit switch
(R) (6)
Limit switch
(L) (7)
Cylinder
sensor (8)
8. Secure the cable with the cable clamp (9).
3025Q
RH-981A
3. INSTALLATION
disconnect the connector
Switch pin Cable color
No.
7 White
12 Black
10 White
15 Black
Brown (Red)
Black (White)
Blue (Black)
before
15-pin
Connector
7
12
10
15
4
9
14
22