Changing Functions Using The Dip Switches; Panel Dip Switches - Brother RH-981A Instruction Manual

11. CHANGING FUNCTIONS USING THE DIP SWITCHES

Always turn off the power supply before changing any of the DIP switch settings.

11-1. Panel DIP switches

The ON/OFF positions of the DIP switches inside the operation panel are checked only once when the power is
turned on.
Any changes to the DIP switch positions will not be effective until the power is switched off and back on again.
No. ON/OFF
ON
1*
OFF
ON
2
OFF
ON
3
OFF
ON
4
OFF
ON
5
OFF
ON
6
OFF
ON
7
OFF
ON
8**
OFF
* If program mode is disabled, operation becomes as follows.
• Program numbers, knife operations and the production counter cannot be changed.
• The modes change in the order Automatic → Test feed → Manual → Automatic.
** If the maximum stitch width correction amount is set to 2.0 mm, carry out the adjustment in "9-14. Adjusting the
position of the work clamp plate". If this adjustment is not carried out, the throat plate and needle plate may
interfere with each other.
If the stitch width correction amount is set to more than 1.0 mm, the sewing speed will be limited in accordance
with the value set.
Program mode disabled
Program mode enabled
Switches between taper bar ←→ straight bar tacking
Normal
Set the feed bracket to the front position
Set the feed bracket to the back position
-
-
Single-pedal operation
Dual-pedal operation
-
-
-
-
Maximum stitch width correction amount = 2.0 mm
Maximum stitch width correction amount = 1.0 mm
11. CHANGING FUNCTIONS USING THE DIP SWICHES
Setting items
RH-981A
2425Q
Default
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
74