Program Setting Method; Parameter Table ( Taper Bar ) - Brother RH-981A Instruction Manual

6. OPERATION

6-3. Program setting method

6-3-1. Parameter table ( Taper bar )

The allowable setting range for some parameters may vary from the range specified, depending on the settings of
other parameters.
No. Setting items
00 Sewing speed
01 Eyelet pattern
02 Button hole length (*1)
03 Tacking length
*1 The Button hole length setting value and the default value vary depending on the machine sub-class.
37
1. Press the SELECT key (1) to change the mode to
automatic, manual or test feed mode.
2. Press the
number (1 - 9) for the independent program to be
changed.
Note: Program mode is not available if a cycle program
has been selected.
3. Press the SELECT key (1). The program mode
indicator (2) will illuminate.
* The parameter number "00" will appear in the
program number display (3), and the parameter
details will appear in the detail display (4).
4. Press the
the parameter to be changed.
5. Press the
setting. (Refer to "Parameter table".)
* The flashing display indicates that the value has
3051Q
not yet been accepted.
6. Press the ENTER key (5) to accept the changed
setting. (The display will then illuminate steadily.)
7. Repeat steps 4 to 6 to change other parameter
settings.
8. Press the SELECT key (1) to change the mode to
automatic mode.
* The program settings will be memorized.
Setting range
1,000 - 2,200 rpm
1 - 6
-00: 5 - 50 mm
-01: 5 - 38 mm
-02 (L1): 14 - 18 mm
(L2): 18 - 22 mm
(L3): 22 - 26 mm
(L4): 26 - 30 mm
(L5): 28 - 32 mm
(L6): 32 - 36 mm
(L7): 36 - 40 mm
0 - 20 mm
RH-981A
and keys to select the program
and keys to select the number of
and keys to change the parameter
Unit Default
100
1
1 -00: 25 mm
-01: 25 mm
-02 (L1): 16 mm
(L2): 20 mm
(L3): 24 mm
(L4): 28 mm
(L5): 30 mm
(L6): 34 mm
(L7): 38 mm
1
1,800
2
6