Changing The Stitch Type To “Border” With A Width Of 3 Mm - Brother PS-300B Instruction Manual

2. In the design area, click to specify the desired location for the start point of the straight
outline (1 in figure below).
3. While holding down the keyboard's Shift key, click to specify the desired location for the
end point of the straight outline (2 in figure below).
4. Right-click once to finish the outline.
The start point marker ("S") and end point marker ("E") for the outline appear.
NOTE: To keep the straight line vertically or horizontally, hold down the keyboard's Shift key while
moving the pointer in the design area.
Changing the stitch type to "Border" with a width of 3 mm:
NOTE: The stitch type is set to Running by default.
1. Click Select on the Shape drop-down menu, or the Select icon
Then click on the outline to select it.
A selection frame of "dashes" appears around the outline to show that it is selected.
2. Change the stitch type to Border in the Stitch Type drop-down list in the tool bar.
25/164
in the toolbar.