To Change The Size Of The Design Elements - Brother PS-300B Instruction Manual

NOTE:
To continue measuring from the end point of the previous measurement, click again to quit the
previous measurement, and then click the same point once more as the start point for the next
measurement.
If Snap Setting
(except the gridlines).
To quit using the Measure tool, right-click once. If no design element has been measured, it will
quit directly. If a design element has been measured, click Cancel on the context menu.

To change the size of the design elements:

You can change the size of all the design elements in the design area with the Measure tool.
1. After specifying the end point with the Measure tool, right-click once, and then click
Resize on the context menu.
The Resize dialog box appears and shows the current length measured.
2. Type in the desired length, and then click the OK button.
A message dialog box appears.
on the Vie w menu is active, the Measure tool snaps to the specified target
153/164