Allied Telesis AT-9900 Series Release Note page 8

CR Module
CR00011349 SYN
CR00011396 PIM on IPv6
CR00011411 PoE
CR00011586 Switch
CR00011587 Switch
CR00011645 Switch
Version 276-03
C613-10474-00 REV B
Level
2 At low baud rates, a synchronous connection was unable to reach 100%
utilisation of the available bandwidth. The queueing mechanism has been
improved to allow 100% link utilisation. Flag sharing between back-to-back
HDLC frames is now supported for synchronous connections.
2 When a user specified a static RP candidate and saved the configuration with the
create config command, the resulting configuration file did not include the RP
candidate. Therefore, rebooting the router or switch deleted the static RP
candidate entry.
This issue has been resolved.
2 When multiple telnet sessions where open on the AT-8624PoE switch, and the
command show switch port was entered, the switch command line became
unresponsive for several minutes.
This issue has been resolved.
2 When a port is no longer a member of any VLAN as an untagged port, it would
discard received untagged BPDU packets.
Note that this issue only occurred on AT-8900 and AT-9900 switches; other
switches already correctly handled untagged frames on tagged ports when
required.
This issue has been resolved.
2 Previously, if a port was a tagged member of a VLAN, it was not able to transmit
untagged frames to that VLAN.
This issue has been resolved. When required, STP BPDUs can now to be sent
untagged out a port, even if the port is configured as a tagged member of a
VLAN.
2 After an AT-8800 series switch was powered down or rebooted, non auto-
negotiating copper GBICs did not correctly handle Ethernet PAUSE frames.
This issue has been resolved.
Description
Features in 276-02
Y Y Y Y - - - -
Y Y Y Y Y - - Y
- - - - - Y - -
- - - - - - - Y
- - - - - - - Y
- - - - Y - - -
8
- -
Y Y
- -
Y -
Y -
- -