Allied Telesis AT-9900 Series Release Note page 20

CR Module
CR00012040 IP Gateway,
WAN load
balancer
CR00012175 OSPF
CR00012265 ATM
CR00012283 Switch
CR00012305 QoS
Version 276-03
C613-10474-00 REV B
Level
3 If policy-based routing and the WAN load balancer were both configured, the
load balancer balanced traffic even if it matched the routing filter. Because the
purpose of policy-based routing is to control the route that traffic uses, this was
incorrect.
This issue has been resolved. Traffic that matches a policy-based routing filter
now bypasses the WAN load balancer.
3 In a segmented NBMA network, in which more than one designated router was
elected for the network, sometimes the router or switch did not add the routes
to the extra designated routers. Note that a segmented network like this only
occurs as the result of an incorrect configuration.
This issue has been resolved. The router or switch correctly determines routes in
such a network.
3 Previously, ATM interfaces stopped transmitting when any of the following
happened:
■
the command reset pri was entered
■
the command reset bri was entered
■
more than two ISDN calls were opened (on Software Versions prior to 2.7.6)
This issue has been resolved.
3 Previously, it was not possible to create two protocol-based VLANs on the same
ports if they had the same protocol but a different Ethernet encapsulation.
This issue has been resolved, so you can now create such VLANs.
3 When a user entered a maxbandwidth for QoS, the switch sometimes displayed
a message that said the bandwidth units were "kbytes" instead of kilobits per
second.
This issue has been resolved.
Description
Features in 276-02
Y Y Y - - - - -
Y Y Y Y Y Y Y Y
Y - - - - - - -
- - - - - - - Y
- - - Y Y Y Y -
20
- -
Y Y
- -
Y -
- -