Allied Telesis AT-9900 Series Release Note page 26

CR Module
CR00011204 IP Gateway
CR00011271 Switch,
Utility
CR00011565 ASYN
CR00011615 Switch
BGP
CR00011724
Version 276-03
C613-10474-00 REV B
Level
- This Software Version allows you to add ARP entries with multicast MAC
addresses and allows the router or switch to accept packets with conflicting IP
and MAC addresses. It introduces the enable ip macdisparity and disable ip
macdisparity commands to support this. For more information, see
Static ARP Entries with Multicast MAC Addresses (CR00011204)" on page
- A new switch filter feature enables you to use a switch filter to make a VLAN
secure without preventing access to other VLANs. For more information, see
"Securing a Single VLAN through Switch Filters (CR00011271)" on page
- When an asynchronous port is in ten mode, it bundles together the characters
that it receives within a certain time period, instead of passing them one at a time
to a higher protocol layer for processing. The time period over which characters
are bundled is called the ten timer. This enhancement enables you to reduce the
length of the ten timer, to improve response times for remote terminal sessions.
For more information, see "Making Asynchronous Ports Respond More Quickly
(CR00011565)" on page 41.
- When a switch port has been given a description, it is now possible to use an
SNMP application to see the port description, through the Interfaces group of the
MIB-II MIB ifDescr OID.
- You can now display:
■
the number of routes learned from a specific peer, by using the existing
command show bgp peer=ip-address
■
information about each route learned from a specific peer, by using the new
peer parameter in the command show bgp route peer=ip-address
For more information see "Displaying Routes Learned from a Specific BGP Peer
(CR00011724)" on page 43.
Description
"Adding
Features in 276-02
Y Y Y Y Y Y
37.
- - - Y Y Y
39.
Y Y Y Y Y Y
Y - Y Y Y Y
Y Y Y Y Y -
26
Y Y Y Y
Y - - -
Y Y Y Y
Y Y Y Y
- Y Y Y