Allied Telesis AT-9900 Series Release Note page 41

Making Asynchronous Ports Respond More Quickly (CR00011565)
When an asynchronous port is in ten mode, it bundles together the characters that it receives within a certain time period, instead of passing them one at a time
to a higher protocol layer for processing. The time period over which characters are bundled is set by the ten timer.
Bundling reduces the load on the CPU by spreading the character processing overhead across several characters. If a remote terminal session is involved,
bundling also reduces the number of packets on the network by sending more characters in each packet. However, it reduces terminal responsiveness. A ten
timer value of 100 milliseconds is generally a good compromise between responsiveness and processing overhead. If you need to increase the port's
responsiveness, this enhancement enables you to reduce the length of the ten timer. To do this, use the new optional tentimervalue parameter in the set asyn
command:
set asyn[=port-number] tentimervalue=20..100 [other optional parameters]
Specify the asynchronous port number unless you are logged in via the port you want to change.
The default tentimervalue is 100 milliseconds, which is the value it was set to before this enhancement.
To display a port's value for the ten timer, use the command:
show asyn=port-number
and check the new "Ten timer value" field, as shown in
"Ten".
Version 276-03
C613-10474-00 REV B
Making Asynchronous Ports Respond More Quickly (CR00011565)
Figure 1. If the asynchronous port is a terminal server port in ten mode, the "Mode" field displays
41