Download Print this page

Allied Telesis AT-9900 Series Release Note page 21

At-8900 and at-9900 series software maintenance release note 276-03
Hide thumbs Also See for AT-9900 Series:

Advertisement

CR
Module
CR00012307
VLAN
CR00012314
TACACS+,
Telnet
CR00012322
Classifier
CR00012329
Asyn
CR00012359
Switch
Version 276-03
C613-10474-00 REV B
Level
3
Previously, when MSTP was configured it was not possible to delete ports from
VLANs in the MSTP CIST, unless MSTP was first disabled.
This issue has been resolved. Deleting such ports is now permitted.
3
If a user connects to the router or switch via telnet and is authenticated using
TACACS+, previously the rem_addr field in the TACACS+ packets contained the
text "Telnet x" (where x was the number of the telnet session) instead of the
remote IP address.
This issue has been resolved. The rem_addr field now contains the remote IP
address.
3
If a user created a classifier that specified an IP address without specifying a
protocol (for example, create classifier=1 ipda=20.20.20.10/24), and saved
the configuration with the create config command, the resulting configuration
file included a value for protocol (for example, create class=1 prot="ip"
ipda=20.20.20.10/24). This prevented the router or switch from applying the
classifier to IPsec tunnelled traffic.
This issue has been resolved. The protocol value is no longer added to such
classifiers, which leaves them matching the default of any.
3
When the router sent a continuous stream of data over a permanent assignment,
and the ASYN port at the receiving end of the tunnel was significantly slower
than the ASYN port at the sending end, the sending router eventually rebooted.
This was because the router had to queue packets and eventually ran out of
memory.
This issue has been resolved. The router now stops receiving ASYN data when
memory is low, so its queue does not get too full.
3
You can now return the description of a switch port to its original blank value by
entering the following command:
set switch port=port-number description=
and providing no value for the description parameter.
Description
Features in 276-02
-
-
-
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
-
-
-
-
Y
Y
Y
-
-
-
-
-
Y
-
Y
Y
Y
Y
Y
Y
21
Y
-
Y
Y
-
-
-
-
Y
Y

Advertisement

loading

This manual is also suitable for:

At-9924tAt-9924spAt-9924t/4spAt-8900At-8948