Allied Telesis AT-9900 Series Release Note page 22

CR Module
CR00012413 Logging
CR00012427 Logging
CR00012468 OSPF
Version 276-03
C613-10474-00 REV B
Level
3 When a user creates permanent log filters, the existing default filter is moved to
the bottom of the list of filters, instead of being deleted. This behaviour is correct.
However, output of the command show config dyn=log previously included
commands to delete the default filter then add it back in, which was confusing.
This issue has been resolved. The output of the command show config dyn=log
now only includes the default filter if the user has specified the default filter in a
command. To see all existing filters, use the command show log
output=permanent full.
3 If a user modified the permanent log by destroying it and creating a new one,
and then saved the configuration with the command create config, the
resulting configuration file included the command destroy log
output=permanent. Therefore when the router or switch restarted it destroyed
the log and all entries.
This issue has been resolved. The command create config now writes the
command set log output=permanent to the configuration file instead of the
destroy and create commands.
3 An OSPF router or switch could show large numbers of entries in its
retransmission lists to certain neighbours under certain conditions (for example,
in a congested Frame Relay network). In some cases, the number of items in the
list was larger than the number of LSAs in the database.
This issue has been resolved.
Also, a new NRL debugging option has been added to OSPF, to show additions
to and deletions from the neighbour retransmission list. To enable NRL
debugging, use the command:
enable ospf debug=nrl
Note that this option may generate large amounts of debugging output on a
large OSPF network. Use it with care.
To disable NRL debugging, use the command:
disable ospf debug=nrl
Description
Features in 276-02
- Y - Y Y - Y Y
- Y - Y Y - Y Y
Y Y Y Y Y Y Y Y
22
Y Y
Y Y
Y Y