Step 5: Remove I/O Fans - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 2

Step 5: Remove I/O Fans

Before you install the SCSI cable, remove the two I/O fans to gain working space
and access to the SCSI B connector on the I/O baseboard.
To remove the I/O fans, refer to Figure 2-4 or 2-5. Grasp one of the I/O fan
modules, depress the latch on the back of the module, and pull the module straight
out from the HP NetServer. Repeat this for the other I/O fan.
Latches on
I/O Fans
Thumbscrew
on Air Baffle
Figure 2-4. Remove I/O Fan from HP NetServer in Pedestal Configuration
12
Installation