HP D7171A - NetServer - LPr Upgrade Manual page 27

Chapter 2
Below are single-bus (no duplex board) hot-swap drive configurations and SCSI
addresses (IDs) for the secondary cage in a rack-mounted HP NetServer. Load
drive modules with all necessary drive spacers starting at the bottom of the cage,
as described in "Installing Hot-Swap Drives" later in this chapter. Filler panels
must occupy all locations without disk drive modules.
10 11 12 13 14 15
Load
10 12 13 14 15
Drive Spacer
Figure 2-13. SCSI IDs for Single-Bus Configurations in Rack Orientation
Drive Spacer
Drive Spacer Drive Spacer
10 12 14
Load
10 12 14 15
Drive Spacer
Drive Spacer
Installation
Drive Spacer
10 11 12 14 15
Load
10 12 13 15
Drive Spacer
Drive Spacer
23