HP D7171A - NetServer - LPr Upgrade Manual page 40

Chapter 3
3. When the Symbios Logic SCSI Configuration Utility Main Menu is
displayed, verify that shows Display=Verbose. (This means that the non-
RAID SCSI devices will be listed on the boot screen.)
If not, use the up and down arrow keys to highlight Display=Terse. Press
Enter to change the setting to Verbose.
4. On the Symbios Logic SCSI Configuration Utility Main Menu, verify that
the Current Status of all Symbios controllers (adapters) is On.
If not, use the up and down arrow keys to highlight Change Adapter
Status. Press Enter to display the Change Status on Next Boot window.
Use the up and down arrow keys to highlight the controller, and press
Enter to change its Next-Boot Status to On. Press Esc to return to the Main
Menu.
5. On the Symbios Logic SCSI Configuration Utility Main Menu, use the up
and down arrow keys to highlight Adapter Boot Order. Press Enter to
select it.
6. The Adapter Boot Order screen displays the two SCSI controllers and
numbers representing their boot order in the following form:
Boot
Order Bus
04
m SYM53C896
where m and n are the numbers 0 or 1 or a blank.
The number in the m position indicates the boot order of the SCSI A
controller, and the number in the n position indicates the boot order of the
SCSI B controller.
0 marks the controller of the SCSI channel searched first for a bootable
drive.
1 marks the controller of the SCSI channel searched second for a
bootable drive.
A blank indicates that the controller's SCSI channel is not searched for
a bootable drive.
To add or change a boot order sequence number, use the right and left
arrow keys to highlight the controller, and then press Enter. Type the new
sequence number (0 or 1), and press Enter. The boot order sequence
number of the other controller will change, if necessary. 0 must be
assigned to a controller before 1 can be assigned to the other controller.
36
Boot
DevFunc Order
28
n SYM53C896
Configure Mass Storage
Bus DevFunc
04 29