Run Symbios Configuration Utility - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3

Run Symbios Configuration Utility

NOTE
Run the Symbios Configuration utility to do the following:
Do the following to run the Symbios Configuration utility:
1. Restart the HP NetServer.
If you receive an error message during the boot process, refer to
"Troubleshooting" in the HP NetServer LH 3000/3000r or LH 6000/6000r
Installation Guide(s) or the online help. Some power-up (boot) messages
are routine.
2. As soon as you see the message
Press Ctrl-C to start Symbios Configuration
Utility...
on the display monitor, press the Ctrl+C keys.
NOTE
If SCSI A and B on the I/O baseboard are operating in RAID
mode, the prompt to press CTRL+C is not displayed. To
change to non-RAID mode, refer to "Run Setup Utility".
If you wait too long to press the Ctrl+C keys, you may not be
able to enter the Symbios Configuration utility, even though
the message "Press Ctrl-C to start Symbios Configuration
Utility..." is still displayed. If this happens, restart the
HP NetServer, and press the Ctrl+C keys as soon as the
message appears.
To verify that devices on SCSI channels A and B are
displayed on the boot screen.
To verify that the controllers of SCSI channels A and B are
set "On" to operate.
To verify that both SCSI channels A and B are searched
for a bootable drive.
To control the order in which SCSI channels A and B are
searched for a bootable drive.
Configure Mass Storage
35