Attach Data Cables To The Server - HP D7171A - NetServer - LPr Manual

Chapter 3
NOTE The configuration in Figure 3-2 requires different power
system configurations at different voltages, as shown below:
230/230/240
For more information on data cabling with the Rack Storage/12FC, see Figure 3-3
and the HP Rack Storage/12 FC Installation Guide.

Attach Data Cables to the Server

1. Locate SCSI connections, label both ends of the SCSI cables, and connect
one end of each one to the server. Tighten captive screws on SCSI
connectors to secure the cable connector to the server connector.
Procedure for Connecting and Routing Cables to the LH 6000r
Voltage Power System Requirements
100 2 PDUs, 3000 VA UPS
120 2 PDUs, 3000 VA UPS
200/208 1 PDU, 3000 VA UPS
1 PDU, 3000 VA UPS
35