HP D7171A - NetServer - LPr Manual page 17

Chapter 1
Managing and Routing Cables
Route cables through the Cable Management Arm and tie-wrap them in
place.
Route cables through Cable Guide and tie wrap them in place.
Powering Up and Powering Down the Components in the Rack
Follow the power up sequence. See "Power Up Sequence" in Chapter 3.
If it becomes necessary to bring the server power down, follow the "Power
Down Considerations" in Chapter 3.
11. Configure the System, Install Doors and Side Panels
At this point, refer to the NetServer user or installation manual and configure the
system.
Install front and rear doors as required, and mount side panels. Look for detailed
instructions and illustrations with the rack enclosure and components.
Preparation for Cabling the HP NetServer LH 6000r
13