Power Distribution Units - HP D7171A - NetServer - LPr Manual

Chapter 2
Notes to Table 2-2.
Note 1. For 100 VAC Systems, separately orderable cables and UPS are available from
American Power Conversion Corporation.
Note 2. Consult American Power Conversion Corporation (APC) for model number of
100 VAC unit.
Note 3. For 100 VAC, consult local electrical codes and order a PDU power cord with
appropriate connector from American Power Conversion Corporation (APC).
Note 4. Limit the 200 - 240 VAC, 10-amp PDU to 10 amps of capacity, plug it into the
200 - 240 VAC 16-amp PDU, and limit both together to 16 amps of capacity.
Note 5. The CEE 7/7 cord is fused for 13-amp loads, and limits the PDU to 13 amps of
total supply.
Note 6. The circuit load should be limited to the VA rating of the UPS when this switch is
used.

Power Distribution Units

Three types of Power Distribution Units (PDU) are currently available for the
LH 6000r, as follows:
The 120 VAC PDU (HP product number E7675A) fits either
horizontally between the columns of the rack or vertically along the
outside edge of the vertical column. See Figure 2-2. This PDU is rated
16-amps unit with nine available NEMA 5-15R receptacles and one
IEC 320 C13 fan receptacle.
The wide-range 200/240 VAC PDU (HP product number E7671A) fits
either horizontally between the columns of the rack or vertically along
the outside edge of the vertical column. See Figure 2-2.This PDU is
rated 16 amps and has six available C-13 receptacles and two C-19
receptacles.
A wide-range 200/240 VAC, 10-amp extension (HP product number
E7670A) can be plugged into the 16-amp unit to extend the number of
C-13 receptacles by an additional 10. This accessory also allows
positioning of receptacles at various levels in the rack. (To order the
16-amp unit with its 10-amp extension and jumper cable, order HP part
number E7672A.)
Rack Cabling References
19